![]() ![]() rods in a cross shape to connect the rings and the battery housing in the center. ![]() Make an inner ring about 4 inches smaller that the outer circle, and use four 1/8-in. Create a housing for the battery mechanism with a short length of metal pipe covered with a round of sheet metal. If you don’t have a frame, try bending ¼-inch steel rod welded to several metal tabs that can be screwed down to a round plywood template the same size as the clock. mild steel rods between the inner and outer loops of the fan. Or, to create Roman numerals, weld short sections of ¼-in. You might be able to find a set of metal clock numbers at a craft store. If you’re lucky enough to find a large old electric radiator/fan, you can re-use the metal circular frame for a clock. Fix the hands to the front of the clock shaft and Voila! A DIY metal clock. ![]() Drill a hole in the center to fit the clock mechanism and securely attach the spindle through the hole, using washers if needed to make a snug fit. Then, using a straight edge, draw a straight line from corner to corner, crossing in the middle, to find the exact center of the piece (don’t remove any protective backing until the project is completed). You could choose a shiny, mirrored finish or a perforated or textured sheet. The simplest method might start with a large square of stainless steel sheet cut to size and sanded or beveled to smooth out any sharp edges. There are a few different ways to create a DIY clock from metal. Thirty inches in diameter is a good size for filling a large block of space, such as a brick or stone fireplace chimney. Looking for a fun DIY project creating a large metal wall clock? This project doubles as wall art, and depending on the way it’s designed, would fit perfectly into a rustic farmhouse, eclectic, modern, or industrial chic décor. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |